---

This amplifier/repeater greatly improves signal strength inside a building when using your cellular phone. It does this without a physical connection to your phone, allowing you to walk freely during a call. It even allows multiple phones to be used simultaneously.

The signal is received by the outside antenna from the cell site. It is then amplified and repeated to your phone through the inside antenna. When the phone transmits it is received by the inside antenna. It is then amplified/repeated to the cell site through the outside antenna.

Specifications
Frequency	824-894 MHz Uplink 869-894 MHz Downlink
Gain	60dB Uplink 60dB Downlink
Flatness	+/- 4dB Uplink +/- 6dB Downlink
Max RF Output Power	+/- 35dB Uplink +/- 10dB Downlink
Noise Figure	3dB nominal
Uplink Downlink Isolation	More than 90dB
Power Consumption	13.8V, 1.5A
Connector	N-Female 50 ohms
Dimensions	5.5 x 4.3 x 1.4 (inches) or 14.0 x 10.8 x 3.5 (cm)
Weight	1.32 pounds or 600 grams
Recommended Distance Between Outside Antenna & Inside Antenna	75 Feet

*	The Wilson Cellular Amplifier / Repeater has a better receiver than what's in your cellphone. Its advanced electronics are very sensitive and able to receive small signals which would go undetected by most cellphones. It also has a better transmitter with double the power of your cellphone. This allows your voice to be heard by distant cell sites, increasing coverage up to 50 miles or more.
**	A cellphone using our amplifier is safer and will use less battery power because the phone thinks it's much closer to a cell site than it actually is. Phones vary their power output based on their proximity to cell sites. Therefore, your phone transmits less power - resulting in safer use and longer battery life.