• Preamble selection is missing
  
• Subnet mask 255.255.255.252 not configurable
  
• Radio driver showing errors in WDS mode while passing high volume of traffic
  
• Disappearing of static route
  
• Memory Leak occurring for models which support remote RSSI feature
  
• Radio hanging at approx 2 million second after reboot.
  

New Features

• Management and Datapath VLAN support
  
• Watchguard can be enabled /disabled
  
• SYSLOG server can be enabled /disabled
  
• Configurable Control frame rate for better IP/MAC Multicast throughput.
  

• Site Survey is not showing correct Root device as it should
  
• Fixes router cache overflow issue when used with p2p applications
  

New Features Added:

• Robust flash locking in place to prevent flash corruption during boot up/reset
  
• Automatic safe mode recovery
  
• Allows RIP to be disabled / enabled
  
• Allows SSID Broadcast to be disabled
  
• WEP Auto mode support
  
• Allows user to add static routes in Bridge mode
  
• ETH-A LED will blink during entire boot up sequence to signify power is on
  
• Improves radio outage detection and recovery time
  
• Allows user to add VLAN management ID to mange the device thru a VLAN
  
• Provides VLAN tagging and un-tagging feature in Remote router/NAT modes
  
• Allows user to see the remote unit RSSI from Link installation page
  
• DFS has been implemented when the device has no WDS clients
  
• Allows user to select a fixed radio transmission rate
  
• Port forwarding in remote NAT mode
  
• Allows user to disable/enable RIP
  
• The channel separation for 2.4GHz is reduced from 40MHz to 20MHz
  

Special Note (sB3021)
In Link Aggregate mode, the watchGuard feature will perform a recovery action when both radios are down. By doing so, this provides maximum link uptime even if one link is lost. In repeater mode, if any one radio link has no association, both radios will be reinitialized. Customers are advised to disable the radio which is not in use to avoid false detection by the watchGuard feature.